The very first device launched by Lancer Skincare allows you to experience optimal exfoliation for face and body.
The PRO POLISH Microdermabrasion Device comes with:
2 Interchangeable Diamond Tips: A smaller tip for the face and a larger tip for the body
200 disposable filters to trap dead skin and keep the device in optimal condition
Tweezers for replacing filters
1 Travel Pouch
Patented 180 degree swivel neck effective for targeting hard to reach areas
3 vacuum suction settings for customized exfoliation on different areas of the face and body
Corded device ensures continuous and consistent professional strength suction
Each device carries a one-year conditional warranty
Safe for all skin types and skin tones
Replacement Tips and Filters sold separately
In an independent consumer research study:
After 2 weeks:
100% agreed skin felt and looked smoother and softer.
96% agreed the device is easy to use on the face and body.
92% agreed rough, uneven texture skin looked improved.
After 4 weeks:
100% saw a visible improvement in fine lines and skin texture.
97% saw a visible improvement in wrinkles.
93% agreed their skin was brighter, more radiant and healthier-looking.
“At Lancer Dermatology, exfoliation is performed with the Vortex-Peel Microdermabrasion machine on nearly every patient to help remove dead and uneven skin cells at the thicker epidermal layer. It renews overall skin tone and texture and helps speed cell turnover, which is the key to younger, fresher, glowing skin.”
– Dr. Harold Lancer
Your PRO POLISH device will come ready to use with the Diamond Face Tip already attached. This tip is for use on your face, hands and smaller body part areas. To change out tips: Ensure the unit is unplugged then simply twist to remove and replace your tip. Always check to make sure there is a new filter in your device before use.
Gently run a fingertip along the rim of the diamond tip to ensure there is nothing too sharp or abrasive. If so, do not use.
Rotate the neck of the device to your desired position by pressing the button on the top side of the device then plug in with A/C plug.
Exfoliating with PRO POLISH:
Start with clean, dry skin - free of oil and make-up.
Locate the on/off switch and push once. The unit will begin suctioning at a low level. This is a great level to start off with on your first microdermabrasion session. Press the button again to increase the suction up to medium and then high levels. Pressing a fourth time will turn the unit off.
Are you ready to GLOW? Pull the treatment area of clean, dry skin tightly. For example, if you would like to start with your cheek, pull the skin tightly with one hand toward your ear. With the unit on your desired setting, place the unit above your jaw and sweep in a short upward motion. Lift the unit off your skin at the top and place again at the jaw and sweep up, making no more than 2-3 short passes over a given area. Check your filter periodically for the need to replace if treating large areas of the body during a treatment session.
UNPLUG AFTER USE. With the unit unplugged, remove and wash the tip in your preferred facial soap with a soft brush (like a toothbrush) then rinse and let dry completely before next use. Change filter after every use.
Recommended use is 1-2x/week with 3 days in between.
Read the enclosed instruction booklet in its entirety before using PRO POLISH.
First Time Users:
If it is your first time using PRO POLISH, we recommend practicing on your hand before using the device on your face. To do this, make a fist with your hand and bend your fist downwards. Notice the tightness of the skin on your fisted hand? Place the unit on the lowest suction setting and sweep in short, upwards strokes from your knuckles toward your wrist. Once you are comfortable using the device, begin your session on the lowest suction setting.